bonestock
Aluminum
- Joined
- Feb 6, 2012
- Location
- Atlanta, Ga
I have a 1996 QT-10 with the basic 8 position turret landing on Friday.
edited: I posted it as a QT-10N but the plate says QT-10, not sure if that makes a difference
I'm looking for
I've already contacted Mazak for the full manual set ($750 for an email, $950 for paper ). I tried to buy email versions then and there but I have to wait a couple weeks until someone in Japan approves the reassignment of the machine into my name.
I'm not intimately familiar with the maintenance on these machines. I've got a pretty tight shop area so having an idea of what sort of wall clearance is needed on the sides or back would be nice. Perhaps some basic install troubleshooting docs.
I believe the machine has been without power for the last week while I have been dealing with knuckle head transport companies. I see mixed threads on how much of a PITA lost parameters are--hopefully I'll avoid that.
In regards to the tool holders, I'm not really finding anything that specifically says it's QT10 compatible. I think the QT8/QT10 may use the same holders but I'm not certain.
edited: I posted it as a QT-10N but the plate says QT-10, not sure if that makes a difference
I'm looking for
- Tplus, Operators, Maintenance manuals
- QT10 ID tool holders.
- ... anything else I should know about this machine.
I've already contacted Mazak for the full manual set ($750 for an email, $950 for paper ). I tried to buy email versions then and there but I have to wait a couple weeks until someone in Japan approves the reassignment of the machine into my name.
I'm not intimately familiar with the maintenance on these machines. I've got a pretty tight shop area so having an idea of what sort of wall clearance is needed on the sides or back would be nice. Perhaps some basic install troubleshooting docs.
I believe the machine has been without power for the last week while I have been dealing with knuckle head transport companies. I see mixed threads on how much of a PITA lost parameters are--hopefully I'll avoid that.
In regards to the tool holders, I'm not really finding anything that specifically says it's QT10 compatible. I think the QT8/QT10 may use the same holders but I'm not certain.