Hi,
Finally ran my first program on my QT10 tonight and I realized that the Z travel is off by a factor of 2. For example I turned a step shaft with a 1" long step and it was only 0.500 long.
Im guessing i need to change a parameter. I did have to reload them. Anybody have any idea which one to change? Its a T1 controller. Thanks.
Finally ran my first program on my QT10 tonight and I realized that the Z travel is off by a factor of 2. For example I turned a step shaft with a 1" long step and it was only 0.500 long.
Im guessing i need to change a parameter. I did have to reload them. Anybody have any idea which one to change? Its a T1 controller. Thanks.
