T-Plus- Any way to set different finish allowance for OD and ID?

ManualEd · Jun 28, 2017

I'm turning some 4340 HT that wont break a chip worth a shit on the ID at .040" doc.
Is there an easy way to set a different ID and OD finish allowance without programming roughing only, and going .080" bigger than the diameter needed on the part?

Thanks!

xa-mont · Jun 28, 2017

ManualEd said:
I'm turning some 4340 HT that wont break a chip worth a shit on the ID at .040" doc.
Is there an easy way to set a different ID and OD finish allowance without programming roughing only, and going .080" bigger than the diameter needed on the part?

Thanks!

You could do a rough path at id-the extra you allowance you want, then a finish path at the desired id

Sent from my LG-H815 using Tapatalk

ManualEd · Jun 28, 2017

xa-mont said:
You could do a rough path at id-the extra you allowance you want, then a finish path at the desired id

Sent from my LG-H815 using Tapatalk

Bingo. Thank you very much!

Gobo · Jun 29, 2017

I believe your TPC should allow you to do that.

Search

Largest Manufacturing Technology Community on the Web

Search

T-Plus- Any way to set different finish allowance for OD and ID?

ManualEd

Stainless

xa-mont

Hot Rolled

ManualEd

Stainless

Gobo

Titanium

Similar threads