clutch
Hot Rolled
- Joined
- Feb 12, 2006
- Location
- Northern LP of Michigan
We have a t32 plus with mazatrol only, no eia, how do we change the programming units and display units to metric, we are in inch atm.
Thanks,
Clutch
Thanks,
Clutch
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
T32 Plus how to change from inch to metric?
- Thread starter clutch
- Start date
- Replies 2
- Views 2,971
Justin_Terry
Hot Rolled
- Joined
- May 13, 2009
- Location
- The Woodlands, Tx
Look at the hard copy of parameters you will see quite a few parameters you have to change. that need to be converted to metric.
Nhuku
Plastic
- Joined
- Aug 15, 2009
- Location
- Australia Brisbane
It surely would be easier just to use the 25.4mm to 1 inch conversion rule against your drawings and pencil them in.
Ive been doing that for over 20 years with my metric machines and its quick enough to do on any drawing. Even easier if you use a good CAD programme just convert the units that way and then punch in the programme in inches into your machine.
Ive been doing that for over 20 years with my metric machines and its quick enough to do on any drawing. Even easier if you use a good CAD programme just convert the units that way and then punch in the programme in inches into your machine.