racen857
Hot Rolled
- Joined
- May 22, 2012
- Location
- pennsylviana, usa
So my night shift "machinist" put a part in the chuck backwards last night causing a big crash. Right now the turret is between tools and about 3 tools out of possition. I can't access the bolts in the turret to begin realinement because they are covered by the turret itsself. rather than behind the open holes. Any thoughts on how I begin with this process. As a side note I have a (turret sensor malfuction 221) alarm I can't rid of.
turning tool, 50% rapids into moving part with a square casting 3 inches accros the flats and 1 inch sticking out too far...............
ready to go do this
turning tool, 50% rapids into moving part with a square casting 3 inches accros the flats and 1 inch sticking out too far...............
ready to go do this