racen857
Hot Rolled
- Joined
- May 22, 2012
- Location
- pennsylviana, usa
Is there a parameter that you can adjust your tools for the Y axis without changing the turret. Most of my tools are on the same Y axis centerline a few are from .004 - .007 off. When I put a y offset in the tool data the machine alarms out after it uses the tool because when the machine returns to the tool change possition it only homes X, Z not Y.
Any help?
Machine is a mazak quick turn nexus 250-II MSY
Any help?
Machine is a mazak quick turn nexus 250-II MSY