Ox
Diamond
- Joined
- Aug 27, 2002
- Location
- Northwest Ohio
Sorry, kan't think of a good title...
Part that I am running right now has an angled cross hole going out the bottom of a hydraulic port on a 20* angle.
The spec shows the C/L of the cross hole tool to be .098 from C/L of the port it'self - at the surface.
How would you guage this?
I put it on the shadowgraph as recommended, but the pic is fuzzy to say the least on round shiny guage pins.
Doo we need a better shadowgraph? A better opperator? Or something different?
I'd rather not post pics of the parts, sorry.
Hopefully my 1000 werds is as good as a pic?
--------------------
Think Snow Eh!
Ox
Part that I am running right now has an angled cross hole going out the bottom of a hydraulic port on a 20* angle.
The spec shows the C/L of the cross hole tool to be .098 from C/L of the port it'self - at the surface.
How would you guage this?
I put it on the shadowgraph as recommended, but the pic is fuzzy to say the least on round shiny guage pins.
Doo we need a better shadowgraph? A better opperator? Or something different?
I'd rather not post pics of the parts, sorry.
Hopefully my 1000 werds is as good as a pic?
--------------------
Think Snow Eh!
Ox