I got my 10EE home into the garage with 3 ton roll-a-lifts, but it will be tough getting it rolled around the back yard to my workshop. I got my 2200 pound Barber Colman gear hobber into the workshop so that is my standard. It is a Wiad type.
My guesses on weights are
Tailstock 100 lbs
Carriage and apron and taper 200lbs
3 hp Reliance motor and backgear gearbox 250 lbs
Threading gear box 40 lbs
Are these weights accurate?
Is it practical to take the headstock off, is it like South Bend, clamps on the ways, or is it jigged and not good to remove it?
Any other weight removing suggestions?
John
My guesses on weights are
Tailstock 100 lbs
Carriage and apron and taper 200lbs
3 hp Reliance motor and backgear gearbox 250 lbs
Threading gear box 40 lbs
Are these weights accurate?
Is it practical to take the headstock off, is it like South Bend, clamps on the ways, or is it jigged and not good to remove it?
Any other weight removing suggestions?
John