What's new
What's new

1944 10EE spindle cuts out over 100 rpm

Yes thats the type and they look all corroded. I'll replace them.
THANKS SO MUCH !!!!!!!!!!




QUOTE=Cal Haines;2650174]If you have the version of the DC control panel with the three resistors in the upper right corner, the problem is probably with two of the resistors. Have a look at this thread.
http://www.practicalmachinist.com/vb/monarch-lathes/start-up-problem-m-g-machine-265676/

If that's not it, get back with me and we'll get it sorted out.

A photo of your DC control panel would be helpful.

Cal[/QUOTE]
 
Jeff,

If the resistors are the problem, you can jumper around the 2000 Ohm resistor, between terminals E and B, and the machine should work just fine. But you need to make sure that you let the spindle come to a complete stop before reversing or restarting it or you may damage something. (You don't need to mess with the 1600 Ohm resistors.)
EE38128 IMG10664 anno.jpg

Cal
 








 
Back
Top