guythatbrews
Titanium
- Joined
- Dec 14, 2017
- Location
- MO, USA
I have the royal collet closer and a monarch step 5c chuck that measures about 3.35" at the end of the closing taper. What I need is the "gear" that fits to the end of the spindle that the thumb tab on the closer locks into. Royal no longer supports this. Can make but would rather not. These are hardened because the fingers that do the work bear on face. If i make one I will use a big thrust washer on the face, $5 from grainger, much cheaper than heat treating!
Also need a d1-3 closer for a standard 5c collet. If I can't get one I think I will make an isert for the step chuck closer to fit the standard collet. Removable of course! Not sure but maybe the one I have is for a 3" step chuck. It has been used gently in its former life.
Anybody out there have anything they might part with?
Thanks!
Also need a d1-3 closer for a standard 5c collet. If I can't get one I think I will make an isert for the step chuck closer to fit the standard collet. Removable of course! Not sure but maybe the one I have is for a 3" step chuck. It has been used gently in its former life.
Anybody out there have anything they might part with?
Thanks!