gregfortin
Aluminum
- Joined
- Nov 20, 2016
Finally got the lathe re wired and running. I'm not sure if this is an indication of a problem but I'm looking for some advise.
When I take the lathe out of gear to turn the spindle over by hand( say to dial in a 4 jaw chuck) I can move the chuck but it takes some force. Ive seen some YouTube videos where the operator can spin the chuck with one finger.
Anyone else found this problem? Thanks, Greg
When I take the lathe out of gear to turn the spindle over by hand( say to dial in a 4 jaw chuck) I can move the chuck but it takes some force. Ive seen some YouTube videos where the operator can spin the chuck with one finger.
Anyone else found this problem? Thanks, Greg