deadlykitten
Banned
- Joined
- Aug 5, 2016
about mill tapping cycle ...
hello
i don't understand this paragraph from chapter 7-11. Tapping Cycle (G84), inside OSP-P300M PROGRAMMING MANUAL
If positioning to the next tapping point is executed at the point R level after the start of the spindle clockwise rotation but before the tapping tool is completely disengaged from the workpiece, enter a dwell at this level by specifying Q
- dwell so the spindle to have time to reach desired rpm before next hole is tapped
- question : what if next hole is a bit far ? so the spindle will reach desired rpm without Q ? kindly !
ps : attached image from manual
hello
i don't understand this paragraph from chapter 7-11. Tapping Cycle (G84), inside OSP-P300M PROGRAMMING MANUALIf positioning to the next tapping point is executed at the point R level after the start of the spindle clockwise rotation but before the tapping tool is completely disengaged from the workpiece, enter a dwell at this level by specifying Q
- dwell so the spindle to have time to reach desired rpm before next hole is tapped
- question : what if next hole is a bit far ? so the spindle will reach desired rpm without Q ? kindly !
ps : attached image from manual
Attachments
Last edited:
