What's new
What's new

LB3000EX Spaceturn Sub-Spindle help

jus2311

Plastic
Joined
Jan 4, 2013
Location
alabama
I need to fat finger a few manual codes for the sub spindle...

OSP200 controller.

Pick off

Pick off with spindles syn and part off

Any offers to help me out plz
 
Here is an basic example of the codes you need:

(PROGRAMMING EXAMPLE)
(SYNC OF MAIN AND SUB SPINDLES)
(USING TORQUE SKIP)
M89 M289 (AIR BLOW A ON & SUB SPINDLE AIR BLOW ON)
M249 ( RIGHT SPINDLE CHUCK UNCLAMP )
M247 (Sub spindle chuck interlock release ON)
G0 W4. ( RAPID SUB SPINDLE TO 4" FROM THE ZERO POSITION )
M88 M288 (AIR BLOW A OFF & SUB SPINDLE AIR BLOW OFF)
M19 M239 (Oriented spindle stop 1 & Sub spindle orientation)
M151 ( SINC SPINDLES )
G97 S100 M3 (SET SYNC'D SPINDLE @ 100 RPM)
G29 PW=40 (SET TORQUE LIMIT USING G CODE TO 40%)
(*****The torque limit value is set as a percentage (%) to the feed axis servo motor rated torque*****)
G22 G94 W0 D.1 L.1 F60 PW=35 (G22-TORQUE SKIP & FEED PER MINUTE MODE)
([Command format] G22 X___ D___ L___ F___ PX__
(W___ PW__; W: Target points D: Relative value of target point and approaching point; L: Relative value of target point and virtual target point; F: Feedrate: PW: Set torque values (%))
G28 (This cancels the torque limit instruction made by G29)
M248 (SUB SPINDLE CHUCK CLAMP)
M185 (Chuck internal interlock release ON)
G4 F.3 (DWELL)
M84 (M84)
G0 W200 ( RAPID SUB SPINDLE AWAY FROM THE PART )
M5 (STOP SPINDLE ROTATION)
M184 (Chuck internal interlock release OFF)
M246 (Sub spindle chuck interlock release OFF)
M150 (Synchronized rotation OFF)
G95 ( BACK TO INCHES PER REV)​
 








 
Back
Top