Limits on 5000G-L?
I'm new to the okuma control and my tools are a long way from where i need to be.
I have a limit light at z-30.0mm and there is still 30-50mm left before the hard limit switch is near it's stop.
before I go mucking around with the limits as detailed in the link below, what should I check to see if there isn't a chuck barrier, tool offset or somthing that is stoping the whole range of motion?
adjusting soft limits
I'm new to the okuma control and my tools are a long way from where i need to be.
I have a limit light at z-30.0mm and there is still 30-50mm left before the hard limit switch is near it's stop.
before I go mucking around with the limits as detailed in the link below, what should I check to see if there isn't a chuck barrier, tool offset or somthing that is stoping the whole range of motion?
adjusting soft limits
Last edited: