TrollTuner
Aluminum
- Joined
- Jul 11, 2015
- Location
- SW Missouri
In regards to this machine a M560-V, the M08 coolant flow is noticeably less than on my Speedio. Looking for some input.
The Okuma uses a Walrus TPAK2-15 1/4Hp. Walrus has a 1/2Hp version. For reference Brother has a 1/3Hp primary pump. Anyone think that would be a reasonable upgrade? Assuming managing the slightly higher current and differing bolt pattern.
I know... Get 1000psi TSC, maybe late next year. Also haven't checked head pressure at the pumps to compare flow.
The catalog:
http://www.walrusamerica.com/Files/TPAK_Cat.pdf
For now we are using the TSCprep Lift pump wired into the Conveyor Wash as a secondary coolant. This only works with the conveyor since the machine faults out if you use the wash button on the control.
Seems it is looking for the relay/breaker feedback from only the Conveyor. They were unable to reassign it. Quite frustrating. If it was DC a couple diodes would make the feedback loop work, however its line volatage AC.
The Okuma uses a Walrus TPAK2-15 1/4Hp. Walrus has a 1/2Hp version. For reference Brother has a 1/3Hp primary pump. Anyone think that would be a reasonable upgrade? Assuming managing the slightly higher current and differing bolt pattern.
I know... Get 1000psi TSC, maybe late next year. Also haven't checked head pressure at the pumps to compare flow.
The catalog:
http://www.walrusamerica.com/Files/TPAK_Cat.pdf
For now we are using the TSCprep Lift pump wired into the Conveyor Wash as a secondary coolant. This only works with the conveyor since the machine faults out if you use the wash button on the control.
Seems it is looking for the relay/breaker feedback from only the Conveyor. They were unable to reassign it. Quite frustrating. If it was DC a couple diodes would make the feedback loop work, however its line volatage AC.