ISO86
Aluminum
- Joined
- Aug 10, 2012
- Location
- VIC, Australia
I have recently been learning to run and program a b300-w multus. We do a family of parts with a slot that goes into a sharp corner. We do this by a combination of horizontal base b and vertical base b. To get into the corner we use the b axis ba=45. Its fine with using horizontal and vertical but when ba=45 the tool is not where the programmed values are. We set the tool off the setter in horizontal b position. We fudge the program values to get why we want but we know it's not correct. Eg if programmed position in ba=45 is (metric) z1 x23 y0 the actual tool position is more like z.7 x21.8 y0. Where are we going wrong? Should it not automatically compensate when in ba based on the x and z offsets for that tool and whatever angle ba is set to?