hello guys,
I have had a robojob robot installed about 4 month ago on a mazak integrex 200IV, the idea is to run the machine lights out with nobody in the workshop although i have came into a few problems. I am hoping someone has had a little more experience than me and could give me some pointers.
The robot is not in a cage so works with a system of a yellow zone and a red zone, so if you are in the yellow zone the robot will run at 25 percent but if you are in the red zone the robot will alarm out completely. the doors open automatically for the robot to take out the finished part and load a new part, when i have been leaving the robot to run during the night i keep getting a alarm where it thinks someone is in the red zone so it will stop completely and wont continue until the alarm is reset and the run button pressed.
I have cleaned the lens which picks up the motion and still seem to get errors, starting to think the change in temperature might be an issue aswell.
If anybody has any information on automisation which may be of use it would be greatly appreciated.
J
I have had a robojob robot installed about 4 month ago on a mazak integrex 200IV, the idea is to run the machine lights out with nobody in the workshop although i have came into a few problems. I am hoping someone has had a little more experience than me and could give me some pointers.
The robot is not in a cage so works with a system of a yellow zone and a red zone, so if you are in the yellow zone the robot will run at 25 percent but if you are in the red zone the robot will alarm out completely. the doors open automatically for the robot to take out the finished part and load a new part, when i have been leaving the robot to run during the night i keep getting a alarm where it thinks someone is in the red zone so it will stop completely and wont continue until the alarm is reset and the run button pressed.
I have cleaned the lens which picks up the motion and still seem to get errors, starting to think the change in temperature might be an issue aswell.
If anybody has any information on automisation which may be of use it would be greatly appreciated.
J