Hi everyone, I’m very new here. I have been reading a few threads concerning watchmaking lathes.
I apologize in advance as I realize this is probably in the wrong section, however I don’t know where else to post this.
I know nothing of a lathe but I’m currently reading George Daniels book on Watchmaking.
It has been become immediately apparent that if I want to get anywhere in this field I need to become intimately familiar with the use of this machine.
Where does one start who has no knowledge of machining??
Any suggestions are helpful.
Please and thanks
Sent from my iPhone using Tapatalk
I apologize in advance as I realize this is probably in the wrong section, however I don’t know where else to post this.
I know nothing of a lathe but I’m currently reading George Daniels book on Watchmaking.
It has been become immediately apparent that if I want to get anywhere in this field I need to become intimately familiar with the use of this machine.
Where does one start who has no knowledge of machining??
Any suggestions are helpful.
Please and thanks
Sent from my iPhone using Tapatalk
