Chknives
Aluminum
- Joined
- Jan 16, 2015
- Location
- Oregon city, Oregon
So today I go to thread with my Weiler Matador (Which recently I've taken apart most of it and cleaned it) which I've never done on this lathe before and it seemed a little coarser thread than I set. So I check and sure enough its way off. So I'm guessing its where the belt feeds disengage because when I feed to the right it feeds at the proper pitch and with gears only, when I try the other way the belt stays engaged. It may be missing parts, like it had no cup washers when I took it apart. I'll try and update tomorrow, but any help would be great. Thanks
