ramiibrahim
Plastic
- Joined
- Aug 14, 2017
Hello,
I'm new to the Forum, so sorry if this has been addressed before. We manufacture many parts that require masking during the platting process. We find that there is always an issue with the masking especially around features being left out. This causes either a lot of rework, or scrapped parts. We just scrapped 20 parts out of a lot of 200 that are $150/pc.
This seems to be a recurring theme. Does anyone else have this problem? How many parts is a reasonable scrap rate due to Masking? Has anyone overcome this issue with their platters?
Any feedback would be helpful Thank you!!
I'm new to the Forum, so sorry if this has been addressed before. We manufacture many parts that require masking during the platting process. We find that there is always an issue with the masking especially around features being left out. This causes either a lot of rework, or scrapped parts. We just scrapped 20 parts out of a lot of 200 that are $150/pc.
This seems to be a recurring theme. Does anyone else have this problem? How many parts is a reasonable scrap rate due to Masking? Has anyone overcome this issue with their platters?
Any feedback would be helpful Thank you!!