Sharp with Fanuc OiMC. I have one program that runs with 4 tools.
I have started to get a stoppage at the last tool change. This only happens once in a while.
The program stops at the tool change line
T8M6
The cycle start light stays lit and the machine stays in cycle.
This of course is intermittent.
I have other parts that run with as many tool changes that run just fine.
This is always from tool 5 to tool 8.
I solved this by ditching the tool change at the end of the program.
What gives?
Any ideas?
Fanuc Tool change strangness
Threaded Mode
