andrewkeisler
Aluminum
- Joined
- Apr 23, 2012
- Location
- Knoxville TN
Machine- 1993 4 axis Fadal 4020HT
Well, I hadn't ran the machine in about two weeks, nor had her turned on. I went out this morning and while trying the cold start procedure, I get an error - "Waiting while slides are being positioned at zero."
When clearing off the cold start and immediately entering the jog command, I get - "Amplifier fault on Y axis. Wait 2 sec. The axis drivers are being reset."
When trying the jog command a second time, I get the same message.
I have checked fuses and reset trip breakers, still the same messages.
Any advise would be greatly appreciated!
Thanks, Andrew
Well, I hadn't ran the machine in about two weeks, nor had her turned on. I went out this morning and while trying the cold start procedure, I get an error - "Waiting while slides are being positioned at zero."
When clearing off the cold start and immediately entering the jog command, I get - "Amplifier fault on Y axis. Wait 2 sec. The axis drivers are being reset."
When trying the jog command a second time, I get the same message.
I have checked fuses and reset trip breakers, still the same messages.
Any advise would be greatly appreciated!
Thanks, Andrew