What's new
What's new

Fadal loosing tool postion

Munimula

Plastic
Joined
Jul 29, 2013
Location
WA
The shop I work at has 4 older Fadal 6030's ranging from 1991 to 2000.

One of them has recently started losing tool position at every power on. Our service tech is 4 hours away and booked out for a while. Anyone have any ideas what would cause this?

Is there a memory battery I should look for that may be dead. We have been very busy at the shop lately and haven't had a chance to dig into the cabinet to look for issues.

Thank you in advance for your time.
 
It's likely the wire harness that goes from the tool carousel to the back of the cabinet, there
is a seal tight tube that has several wires running through it, the wires inside get frayed and start
shorting out.
 








 
Back
Top