Hi Tojan, I rooted around in the shop and used what I had,which was a piece of 3/4" thick piece of aluminum flat bar. I milled it out to fit the keypad.The cable is held on through the connector screws,but the panel has two screws that mount it to the housing,seems stout enough,but you could always add an ADEL clamp or something to beef it up,I probably will once I get my enclosure and mount the drive.Jim
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.