rammerc
Cast Iron
- Joined
- Jul 17, 2004
- Location
- St. Pete. Florida USA
Gentlemen,
I started a thread in the Antique Machinery section, Moving Sale -- I mentioned I had 25 small lathes and needed to thin my collection. I recently listed a real nice 9 inch South Bend so thought I would also post it over here. This is a bench top rear drive but loaded. Milling attachment, Jacobs spindle chuck, three and 4 jaw chucks, two fixed steadies , two traveling steadies, collet adapters for 3C and 3AT with collets and draw bars, face plates etc.
I hope to get 1300 OBO. It is sitting in the back of my custom trailer on the floor and would like to sell it before my move North of St Pete Fl To our new home on the Withlacoochee.
Any interest contact me at my email address [email protected]
Rick
I started a thread in the Antique Machinery section, Moving Sale -- I mentioned I had 25 small lathes and needed to thin my collection. I recently listed a real nice 9 inch South Bend so thought I would also post it over here. This is a bench top rear drive but loaded. Milling attachment, Jacobs spindle chuck, three and 4 jaw chucks, two fixed steadies , two traveling steadies, collet adapters for 3C and 3AT with collets and draw bars, face plates etc.
I hope to get 1300 OBO. It is sitting in the back of my custom trailer on the floor and would like to sell it before my move North of St Pete Fl To our new home on the Withlacoochee.
Any interest contact me at my email address [email protected]
Rick
