Azmotorhead
Plastic
- Joined
- Oct 30, 2011
- Location
- Peoria,AZ.
Finally got my 9c all apart and cleaned up ready to restore.
Problem i see is the main shaft and corellating bearing surface are a bit scored.
Should i just clean it up a bit and run it or should I be turning the shaft down and make a new bearing for it to ride on?
This is just a small Hobby lathe ,I have a 9a waiting for its resto and that one will be my one for main use.
Problem i see is the main shaft and corellating bearing surface are a bit scored.
Should i just clean it up a bit and run it or should I be turning the shaft down and make a new bearing for it to ride on?
This is just a small Hobby lathe ,I have a 9a waiting for its resto and that one will be my one for main use.