HI All,
a long while ago I purchased an ER32 collet chuck for my SB9B, it was brand new and listed on a popular auction site as for a boxford but looked to be the right thread, it is all one piece not a backplate and bolt on type (the same as the link below), my questions is, it only seems to thread on about a half turn then binds up, I have read that it may be the wrong pitch, which I will try to check tomorrow when I can get to it (any suggestions for checking the internal thread pitch?), but is there anything I can do if it is? anything else I should try to get it to fit? and has anyone else used one of these with any success?
Redirect Notice
a long while ago I purchased an ER32 collet chuck for my SB9B, it was brand new and listed on a popular auction site as for a boxford but looked to be the right thread, it is all one piece not a backplate and bolt on type (the same as the link below), my questions is, it only seems to thread on about a half turn then binds up, I have read that it may be the wrong pitch, which I will try to check tomorrow when I can get to it (any suggestions for checking the internal thread pitch?), but is there anything I can do if it is? anything else I should try to get it to fit? and has anyone else used one of these with any success?
Redirect Notice