grahamkmiller
Plastic
- Joined
- Jun 20, 2017
Hello all, I recently purchased a South Bend 13 inch with the 60 inch bed and successfully transported it home. It came with a minimal amount of parts & pieces and tooling. For the headstock, it came with a 3-jaw chuck that fits the 2.25 x 8 tpi spindle. I am interested in picking up a 5c collet set and the necessary parts to use them. I understand I need a drawbar, I assume with a hand wheel, and some sort of holder for the collets at the spindle end. What else am I missing. I have not been able to find out much regarding this assembly, so I could use any advice you can give. Do the parts off other SB models interchange at all? Pictures or a drawing would help too.
I have no instant need for theses, but since I am on ebay all the time, I would like to know what to look for. I also have some ability to make things, between the SB and a Bridgeport I bought earlier in the year.
Thank you
Graham
I have no instant need for theses, but since I am on ebay all the time, I would like to know what to look for. I also have some ability to make things, between the SB and a Bridgeport I bought earlier in the year.
Thank you
Graham