Rudd
Stainless
- Joined
- Jul 30, 2003
- Location
- savannah, jaw-ja
I think I remember some instructions on installing a taper attachment on a lathe, if I recall correctly there was something about babbiting parts in place. Does anyone have their finger on this info? I searched over a VM and in the stickies up top and didn't see anything.
Thanks in advance.
Edit - I found the instructions for installing one on a 9" lathe over at SBL Workshop, but that's not for the telescopic TA used on the 13".
Thanks in advance.
Edit - I found the instructions for installing one on a 9" lathe over at SBL Workshop, but that's not for the telescopic TA used on the 13".