Looking for a part for my SBL 13

Bamban · Apr 19, 2018

I am looking for the key, #18 on the parts list for my SBL 13, of you have one please let me know. And I am also looking for advice on how to remove the old one. Finally found the set screw holding the key, it was buried underneath layers of paint. Removed the set screw, and tried desperately to grab the key with a bent needle nose pliers it would not budge. It must stuck in there good, or there is a known trick on how to get it out.

iwananew10K · Apr 19, 2018

Pics too small to see but if it's the key in the casting that the slot on the bottom of the tailstock spindle rides on....it is at a 45 degree angle...just use a small hammer and punch to drive it into the bore until it falls out.

It is just a round pin, cut to a 45 angle on one end with flats milled into it.

Bamban · Apr 19, 2018

iwananew10K said:
Pics too small to see but if it's the key in the casting that the slot on the bottom of the tailstock spindle rides on....it is at a 45 degree angle...just use a small hammer and punch to drive it into the bore until it falls out.

It is just a round pin, cut to a 45 angle on one end with flats milled into it.

The key is in a slot, I will try harder in driving it out of the pocket.

iwananew10K · Apr 19, 2018

You might post a pic...there may be variations I am unaware of...a pic will tell the guys for sure.

Search

Largest Manufacturing Technology Community on the Web

Search

Looking for a part for my SBL 13

Bamban

Plastic

Attachments

iwananew10K

Diamond

Bamban

Plastic

iwananew10K

Diamond

Similar threads