Motor pulley on 13"

**gkemper** · 12-13-2010, 09:17 AM

I have a 13" that came with a new motor. The problem is it also has a new single sheave pulley that I know isn't original. My concern is that the new pulley isn't the correct diameter.

Does anyone know the correct size pulley for the motor?

Thanks

**aametalmaster** · 12-13-2010, 09:40 AM

It would be a double pulley with both being the same. There were 3 sizes.
2 17/32"
2 63/64"
4 21/64" all with differnt bores to suit the motor...Bob

**gkemper** · 12-13-2010, 01:46 PM

Thanks!

I didn't mention that it didn't come with a belt either.

Is it just a standard 1/2" belt?

Do you have a part number? I'll figure out the length.

**aametalmaster** · 12-13-2010, 02:22 PM

Yes that would be for a 1/2" belt as the drawing shows .490 on the groove width. I don't have any belt lengths avail to me just pulley drawings. If your pulley is about 3" i would give it a try and see how it runs then you can make a dual pulley to suit...Bob