MrChips
Plastic
- Joined
- Aug 2, 2013
- Location
- Mesa Arizona
I have a old SB lathe where the tail stock has a small 3/8" chuck and the taper that fits into the tail stock is stamped Jacobs Hartford Conn, it is 3.1" long, the large end is 0.703" and the small end is 0.595"
The chuck I want to mount on the new taper adapter is a Jacobs 34B
It has writing that says Sheffield, THD 5/8 x 16, 0-1/2in, 0-13mm.
So I need a adapter taper that fits the Jacob 34B chuck and also fits the tail stock as described above.
I see a lot of taper adapters on EBay but I am not sure which one I need, can someone tell me what I need?
Thanks
HH
The chuck I want to mount on the new taper adapter is a Jacobs 34B
It has writing that says Sheffield, THD 5/8 x 16, 0-1/2in, 0-13mm.
So I need a adapter taper that fits the Jacob 34B chuck and also fits the tail stock as described above.
I see a lot of taper adapters on EBay but I am not sure which one I need, can someone tell me what I need?
Thanks
HH