Here are a couple of pictures of the micrometer stop mounting bracket on the lathe.
As was stated before, there are a couple of tapped holes in the side of the bed ways to accept the mount.
Micrometer mounts on this without the bottom part of the clamp that is needed when clamping the micrometer on the ways. The micrometer stop attaches to
the mount better in my opinion, if a cap screw that is about 1/2 inch shorter than the one used with the micrometer stop clamp. That way, the mounting screw won't stick out the other side of the bracket.
Sorry for the blurry photos.
CWC(4)