The QCTP that came with my lathe is undoubtedly an import and has no maker's mark. Aside from the T-slot adapter being pathetically hacked up to fit, it seems to be in good condition. It doesn't match any of the images I found on the internet, but resembles a couple of them.
I agree, looks exactly like my early Aloris that has a sticker on it. Right down to the ridge on the black knob where it meets the steel shaft. If I remember, I snap a picture of it and post it u.
What does the underside of yours look like? Do you have the cyl that goes in the hole?
I agree, looks exactly like my early Aloris that has a sticker on it. Right down to the ridge on the black knob where it meets the steel shaft. If I remember, I snap a picture of it and post it u.
What does the underside of yours look like? Do you have the cyl that goes in the hole?
Yes, I have the cylinder and bolt, and a very hacked up T-Nut:
Thanks for the info, gentlemen. I take back my assertion that it's "undoubtedly an import." The bolt thread is 9/16-18, and the bolt and nut seem to be very good quality.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.