I'm going to change out my spindle. But before I pull out the old one I'm wanting to have ALL the replaceable parts replaced or ready to go back in. I have the take up nut, needle bearing replacement for the washer, thrust bearing, pulley cone, bull gear. My Question; On this Lathe made in 1935 or 36 . It's a top oiler ,and there appear to be some felt washer/gaskets just inside the outer edge of the bearing casing around the spindle ,in a groove . This would be to help retain oil in the bearings I assume. I have searched and have not found or seen these washer/gaskets spoken of or made available for sale in any rebuild kit. Any info on this would be appreciated.
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Question about my SB 9c 415
- Thread starter CKpipa
- Start date
- Replies 5
- Views 1,068
iwananew10K
Diamond
- Joined
- Sep 12, 2010
- Location
- moscow,ohio
can you provide a pic?
Depending,there are some differences that may or may not apply.
Why are you replacing the spindle?
Depending,there are some differences that may or may not apply.
Why are you replacing the spindle?
