dizzolve
Plastic
- Joined
- Nov 21, 2017
I'm restoring my 13" and ran into a couple stubborn taper pins in the Apron which I had to drill out.
Can anyone help with the sizes I'll need? I could take some measurements but I wanted to bounce this off all the experience in here before I chase my tail
Thanks in advance!
PS - one appeared to be just under 1/4 inch major (Handwheel crankshaft gear inside the apron I think it was)...
...and the other was through the threaded ring that retains the worm gear bushing so it was like maybe 1/8" but probably smaller
I wouldn't mind buying bulk assorted if that's possible. Any advice is welcome
Robert
Can anyone help with the sizes I'll need? I could take some measurements but I wanted to bounce this off all the experience in here before I chase my tail
Thanks in advance!
PS - one appeared to be just under 1/4 inch major (Handwheel crankshaft gear inside the apron I think it was)...
...and the other was through the threaded ring that retains the worm gear bushing so it was like maybe 1/8" but probably smaller
I wouldn't mind buying bulk assorted if that's possible. Any advice is welcome
Robert