dusty1313
Plastic
- Joined
- Jan 18, 2008
- Location
- scottsdale arizona
Looking for a good condition 8" Junior if anyone has one available ? Thanks. Please send a couple photos and condition report.
Dusty
Dusty
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
WTB: 8x36 SB Junior
- Thread starter dusty1313
- Start date
- Replies 8
- Views 1,920
comstockfriend
Hot Rolled
- Joined
- Aug 11, 2013
- Location
- Sun Valley, California, USA
I have one available (and in SoCal), but I would not call the condition "good". It's in pieces but most all there, I believe with a four jaw and faceplate (not the same 1.5"-8 thread as the 9's, maybe 1.5"-10???). Would be next week before I could get some photos...
John
John
comstockfriend
Hot Rolled
- Joined
- Aug 11, 2013
- Location
- Sun Valley, California, USA
Well, found a few photos:
Thread dial is on another lathe now and is NOT included.
John
Thread dial is on another lathe now and is NOT included.
John
comstockfriend
Hot Rolled
- Joined
- Aug 11, 2013
- Location
- Sun Valley, California, USA
More photos:
The shims are from when I was using the headstock on my old 9" Model C with the C's MT2 tailstock quill. The Junior tail stock is MT1.
The Serial Number is 51316
John
The shims are from when I was using the headstock on my old 9" Model C with the C's MT2 tailstock quill. The Junior tail stock is MT1.
The Serial Number is 51316
John
comstockfriend
Hot Rolled
- Joined
- Aug 11, 2013
- Location
- Sun Valley, California, USA
The drive is pretty much standard horizontal, almost like my 9"er, it's all there, less motor (I probably have the 1/4 or 1/3 HP that came with it to me. It hasn't run since 1985. (The head stock and drive were used on a 9" Model C with badly worn out headstock bearings from being used as a speed lathe, hence the shims in the photo above.)
John
John
dusty1313
Plastic
- Joined
- Jan 18, 2008
- Location
- scottsdale arizona
Wanting an 8" Junior as I already own two different 9" , a 10 Heavy, a 13" and a 16" machine. An 8" sounds like the perfect small size to me.
comstockfriend
Hot Rolled
- Joined
- Aug 11, 2013
- Location
- Sun Valley, California, USA
In addition to this little guy, I have a 9" Model C, 9" Model A CL644A 16 speed with V-belt (horizontal drive), a new to me 9" Model A CL344ZN UMD, a 13" CLC145B and another incomplete 13" with USN anchor on the ways. I could probably use the space...
John
John
dusty1313
Plastic
- Joined
- Jan 18, 2008
- Location
- scottsdale arizona
John...did you ever get that 8" SB Junior all put back together ? I may still have an interest if its for sale and all there now ? Thanks. [email protected] .
dusty.
dusty.
