I'm looking for a 5C collet chuck for my SB 13" 8145 lathe (11446TKL14). I need the draw bar, collet sleeve, and the spindle nose cap. It has the large spindle hole.
Anyone have these for sale and/or is there a supplier I could source them from?
I found this chuck doing a search: Plain Back 5C Collet Chuck Lathe Use | eBay
Anyone have any experience with one or heard pros/cons of it?
It seems it would serve my purposes and I have an extra back plate to mount it on.
I have a Bison 5C chuck similar to the one you're looking at. The only negative thing I can think of is that it takes a lot of winding of the chuck key to tighten or loosen the collet. If you're not in a hurry, no big deal. Mine is very accurate, within .001"
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.