Thread: WTB: SB Heavy 10 Carriage Stop

Title says it all. Looking for an SB Heavy 10 carriage stop in nice condition.

Nitromahn
I have three micrometer stops that I would like to sell. I think one is a South Bend and might be for a heavy 10. I'll look and post some photo's later.
Andy

Sounds good Andy. The measurement is 1 3/4" from the center of the stop pin to the center of the V. This is the one I'll need.

A lathe stop is a pretty simple and rudimentary piece of equipment. You are a machinist, make one.

Originally Posted by tailstock

A lathe stop is a pretty simple and rudimentary piece of equipment. You are a machinist, make one.

Well sir...thank you for the encouragement, though I think "machinist" at this time may be premature. Budding machinist is more accurate.

The bottom one is a SB but I'm sorry to say it must be for a smaller lathe. The number you wanted is closer to 1.250". The stop is marked South Bend and MCS-103NK.
The middle one looks like a Rockwell / Delta 11" and not sure of the top one but to big for you.

Andy

Thanks for taking the time to get the photo up Andy. You are correct, they won't work for me.

Thank you though.