JRIowa
Diamond
- Joined
- May 27, 2003
- Location
- Marshalltown, Iowa, USA
Free! You pay shipping
1. Aloris BXA-16 turning and facing holder. This holder uses TPG-32X inserts. Needs shims, screws etc. Been sitting on my desk for 20 years and needs to go. I think it will fit in the smallest USPS priority box.
2. SECO MTENN-24 insert holder. This uses TNMG-54X inserts and is probably not for a hobiest. 1.500" square shank. One of the brilliant operators at work install in the lathe @ 90 deg off. It wouldn't stay in so... he had it welded! After it was cut out, it came to my desk. So, it's got 3 spots on each SIDE where it was tacked. Again, I think it will fit in small box.
If you want either, send me a PM with your shipping address. I will mail to you in cheapest package possible. My address and the cost will be inside, just mail me a check so I can give to SWMBO. I'm thinking shipping will be less than $20.
JR
1. Aloris BXA-16 turning and facing holder. This holder uses TPG-32X inserts. Needs shims, screws etc. Been sitting on my desk for 20 years and needs to go. I think it will fit in the smallest USPS priority box.
2. SECO MTENN-24 insert holder. This uses TNMG-54X inserts and is probably not for a hobiest. 1.500" square shank. One of the brilliant operators at work install in the lathe @ 90 deg off. It wouldn't stay in so... he had it welded! After it was cut out, it came to my desk. So, it's got 3 spots on each SIDE where it was tacked. Again, I think it will fit in small box.
If you want either, send me a PM with your shipping address. I will mail to you in cheapest package possible. My address and the cost will be inside, just mail me a check so I can give to SWMBO. I'm thinking shipping will be less than $20.
JR