FS: Random Collets and Tool Holders, 2J, 3H, 5C, Warner Swasey

I have some random collets and tool holders that need to find a new home. I don't know what all of the tooling is so please have a look at the pictures.

Hardinge 2J x 3/8" collet $5 + shipping
Index of /PM/parts/2J

Hardinge 3H x 3/4" collet $5 + shipping
Index of /PM/parts/3H

Hardinge 3H x 7/8" collet $5 + shipping
Index of /PM/parts/3H-2

Hardinge 3H x taper adapter $5 + shipping. I haven't measured the taper if there is interest I will measure the taper
Index of /PM/parts/3H

Hardrige 5C x 1 1/2" collet $10 + shipping
Index of /PM/parts/5C15

Hardrige 5C x 1 3/4" collet $10 + shipping
http://joatis.com/PM/parts/5C175/

13/16" collet $1 + shipping
http://joatis.com/PM/parts/40IAT/

Warner Swasey tool holder $2 + shipping
http://joatis.com/PM/parts/swasey_1/

Maybe a Warner Swasey tool holder? $2 + shipping
http://joatis.com/PM/parts/swasey_2/

Unknown tool holder $2 + shipping
http://joatis.com/PM/parts/unk_1/

PM sent on the 5C Collets

What is the outside diameter of the warner and swasey tool holder? I'd look up the number, but can't find the book!

rudolf -
I'll take the 1.5" 5C collet, if post#2 has not already nailed it down. PM coming.
-Marty-

I did some measuring and some more picture taking. Both of the Warner Swasey directories have been updated with the additional pictures to show what is written in the text below about Morse tapers.

'Warner Swasey tool holder $2 + shipping' additional information:
O.D. = 1.50"
ID = Morse taper 4
Length = 5.745"

Index of /PM/parts/swasey_1


'Maybe a Warner Swasey tool holder? $2 + shipping' additional information:
O.D. = 1.50"
Length = 4.879"
Flat along length of tool holder = .50"
I.D. = Morse taper 4
* there is an adapter sleeve inside this tool from Morse 4 to Morse 3. I took it out and took pictures of it and the holder with drills inserted in the tapers.
The taper adapter comes with the tool.
The measurements seem to give more credence to the idea that this is also a Warner Swasey tool holder.


'Unknown tool holder $2 + shipping' additional information:
O.D. = 1.2670"
I.D. = 1.250"
Length = 4.770"


'Hardinge 3H x taper adapter $5 + shipping. I haven't measured the taper if there is interest I will measure the taper' additional information:
Taper small end = 1.3560"
Taper large end = 1.50"
Taper length = 3.05"
Index of /PM/parts/swasey_2

ponderingjunkman said:

What is the outside diameter of the warner and swasey tool holder? I'd look up the number, but can't find the book!

Click to expand...

Please have a look at the new information in the post above this one.

Thanks for the additional measurements! I'll take both those holders that measure 1.5 inches outside diameter. PM coming