jmhoying
Hot Rolled
- Joined
- Apr 3, 2013
- Location
- Western Ohio
Hardinge-Sjogren Speed Collet Chuch for L0 lathe mount - Uses 2J collets - VERY heavy duty unit - $350.00
Shown on my Cincinnati Hydrashift 10x36, which works, but it should be on a 12" or bigger lathe.
Runout is about .0005 - A short video showing the runout - http://jackhoying.com/jack/kr/chuck.MOV (ignore my noisy lathe headstock at low RPM)
Buyer pays shipping, but you are free to pick it up in Fort Loramie, Ohio (Western Ohio. Also, I'll be traveling down I-75 to Florida in November if you'd want to meet along that route.
(Same video as above, but on YouTube instead)
Shown on my Cincinnati Hydrashift 10x36, which works, but it should be on a 12" or bigger lathe.
Runout is about .0005 - A short video showing the runout - http://jackhoying.com/jack/kr/chuck.MOV (ignore my noisy lathe headstock at low RPM)
Buyer pays shipping, but you are free to pick it up in Fort Loramie, Ohio (Western Ohio. Also, I'll be traveling down I-75 to Florida in November if you'd want to meet along that route.
