FV1365 Tool change program
Close
Login to Your Account
Results 1 to 2 of 2
  1. #1
    Join Date
    Mar 2011
    Country
    UNITED STATES
    State/Province
    Connecticut
    Posts
    2
    Post Thanks / Like
    Likes (Given)
    1
    Likes (Received)
    0

    Default FV1365 Tool change program

    I cannot for the life of me find the tool change program on this machine with the Fanuc 0i-MD controller.

    So far I've changed 3202 NE9 and PSR to allow for searching and editing of the 9xxx programs but still no luck. I have made and edited a 9xxx program but that is the only one that will show up in the directory. I've also seen reference to parameter 10 bit 4 but this controller does not have that bit labeled as mentioned in a few other threads on here have suggested.

    I vaguely remember a former maintenance tech say that the tool change was done through the ladder only without its own program.

    Have any of you run into this before?

    -Alex

  2. #2
    Join Date
    Mar 2011
    Location
    MASS
    Posts
    705
    Post Thanks / Like
    Likes (Given)
    313
    Likes (Received)
    246

    Default

    Are you trying to get the machine not to travel g28 x0 y0. Before the tool change? I have a fv1050s and would suggest you call toyoda and ask for Jim gibbler he's toyoda main vmc tech


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •