I put a call into American Rotary customer service which "will" call me back, but am throwing this out there to see if anyone will bite.
I picked up this RPC which is way to large for my needs.
So my problem is I have the box with 5 double lugs coming out of it. Two of the lugs on the right side (top in top photo) I have a good feeling are the L1 and L2 single phase inputs. The left side (bottom in top photo) has three double lugs which are not labeled and I can only assume are the idler inputs/outputs.
So How can I tell which input is what for the wires coming in from the idler. American rotary on their new units state that lug A should have wired pair from motor 1,7 etc, etc.
I have a brown and a orange 10ga wire coming into the single phase inputs off a 50AMP breaker. Only because I will have no load on this motor and believe I'll be safe during start up.
<br /><br />
<br /><br />
I picked up this RPC which is way to large for my needs.
So my problem is I have the box with 5 double lugs coming out of it. Two of the lugs on the right side (top in top photo) I have a good feeling are the L1 and L2 single phase inputs. The left side (bottom in top photo) has three double lugs which are not labeled and I can only assume are the idler inputs/outputs.
So How can I tell which input is what for the wires coming in from the idler. American rotary on their new units state that lug A should have wired pair from motor 1,7 etc, etc.
I have a brown and a orange 10ga wire coming into the single phase inputs off a 50AMP breaker. Only because I will have no load on this motor and believe I'll be safe during start up.
<br /><br />
<br /><br />