flexy
Plastic
- Joined
- Aug 30, 2008
- Location
- North east England
I recently purchased an inverter to convert a three phase lathe to run on a single phase supply, the only snag I have run into, is converting the motor from a star to a delta configuration,There are only four terminals in the motor box , It is a Brook crompton dual voltage motor made in UK.
http://www.photography.tomwarlow.co.uk/v/gallery/Links/_TOM6845-Edit.jpg.html
There are terminals A, B, C and N
The three brown power wires are attached to each of A ,B and C
A has a red wire going from it
B has a yellow wire
C has A blue wire
N has three wires connected - white, grey and brown,
How do I re wire to get the motor to run in the lower 220V delta configuration?
http://www.photography.tomwarlow.co.uk/v/gallery/Links/_TOM6845-Edit.jpg.html
There are terminals A, B, C and N
The three brown power wires are attached to each of A ,B and C
A has a red wire going from it
B has a yellow wire
C has A blue wire
N has three wires connected - white, grey and brown,
How do I re wire to get the motor to run in the lower 220V delta configuration?