I purchased an IME lathe complete with a 1950's/60's General Electric motor and incapacitator. The board the motor and lathe were situated on was a tad tatty, so I decided to make a new one. During the course of which I had to disconnect the wiring and made a diagram of where the three wires were attached. Unfortunately, this diagram was inadvertently disposed of.
I would therefore be grateful for any advice on how to rewire the motor. I enclose images of the motor and incapacitator situated on my new board. There are three wires emanating from the motor, the colours being brown, turquoise blue and yellowish light brown.( these hues may be the result of fading) The brown and blue wires have spade connectors which I presume are attached to the capacitator which has two posts, each with two connectors to take the spade connectors on the wires, but I don't know which one goes where. The other yellowish brown wire doesn't have a connector and I presume this is the live feed which connects to the switch.
The data on the motor reads;-
General Electic,
Model.5KPM49FG166
HP 35M RP11 1600/1300 V.230
AO 25/ 0.31 CY 60/50 PH1
CAP. 1.5 MFD RUT CCW 0CV
Time Rating. CONT.
The Incapacitator,
68 12 60cy
Made in USA,
49E615 151
5UC 370V
I thank you in advance for any assistance that may be able to be afforded me on this matter.
I would therefore be grateful for any advice on how to rewire the motor. I enclose images of the motor and incapacitator situated on my new board. There are three wires emanating from the motor, the colours being brown, turquoise blue and yellowish light brown.( these hues may be the result of fading) The brown and blue wires have spade connectors which I presume are attached to the capacitator which has two posts, each with two connectors to take the spade connectors on the wires, but I don't know which one goes where. The other yellowish brown wire doesn't have a connector and I presume this is the live feed which connects to the switch.
The data on the motor reads;-
General Electic,
Model.5KPM49FG166
HP 35M RP11 1600/1300 V.230
AO 25/ 0.31 CY 60/50 PH1
CAP. 1.5 MFD RUT CCW 0CV
Time Rating. CONT.
The Incapacitator,
68 12 60cy
Made in USA,
49E615 151
5UC 370V
I thank you in advance for any assistance that may be able to be afforded me on this matter.
