llf264
Cast Iron
- Joined
- May 18, 2006
- Location
- Ft. Worth, TX
My German lathe has three hot leads which I have figured out... and PE is the ground apparently... so what is N?
I guess this brings me to another final question... what the heck is the difference ground and Nuetral.
I know that code will be different in different places... but if ALL of my junction boxes, panels, machines, RPC's, and conduit on down the line are ALL connected back to ground bus (connected to the big white wire in the load center)is that a poor practice for a specific reason?
I guess this brings me to another final question... what the heck is the difference ground and Nuetral.
I know that code will be different in different places... but if ALL of my junction boxes, panels, machines, RPC's, and conduit on down the line are ALL connected back to ground bus (connected to the big white wire in the load center)is that a poor practice for a specific reason?