Todesengel
Plastic
- Joined
- Feb 24, 2018
Just picked up a 17E and was looking for a little advice from the more knowledgable members as far as wiring this thing up. I have three phase in my hobby shop but not 460 service and of course the lathe is 460. I am considering just replacing the motor (and if this is the preferred method I would appreciate suggestions on that as well) or maybe a transformer.
I ran the lathe at its previous home and it ran very nice and I really like the weight of this thing, it's a whale.
Any input is greatly appreciated.
I ran the lathe at its previous home and it ran very nice and I really like the weight of this thing, it's a whale.
Any input is greatly appreciated.