mitty38382
Hot Rolled
- Joined
- Apr 18, 2006
- Location
- Trenton, Tennessee
Hi Everyone
The Power Distribution Block in my 40 HP Panel seems kind of tight with the #2 AWG wire and having to add the wire going to the machine. Am I doing something wrong?
I replaced the Incoming contactor with the new one from WNY Supply and ran the wire to the breaker panel. Ready to run wire from Distribution Block to motor and wow - seems kind of tight for getting #8 or #6 wire into the same hole with the #2 AWG
What is the right size conduit for 3 -#2 AWG runs to motor (which is outside).
What size wire for a 40 AMP load on the CNC (#8 or #6)
Is the Marathon Cat# 1423572 Power Distribution Block the right size or should I go with a different one. http://www.marathonsp.com/MSP Catalog/2006 Catalog pdfs/FULL CATALOG.pdf
Frank S. in Tennessee
The Power Distribution Block in my 40 HP Panel seems kind of tight with the #2 AWG wire and having to add the wire going to the machine. Am I doing something wrong?
I replaced the Incoming contactor with the new one from WNY Supply and ran the wire to the breaker panel. Ready to run wire from Distribution Block to motor and wow - seems kind of tight for getting #8 or #6 wire into the same hole with the #2 AWG
What is the right size conduit for 3 -#2 AWG runs to motor (which is outside).
What size wire for a 40 AMP load on the CNC (#8 or #6)
Is the Marathon Cat# 1423572 Power Distribution Block the right size or should I go with a different one. http://www.marathonsp.com/MSP Catalog/2006 Catalog pdfs/FULL CATALOG.pdf
Frank S. in Tennessee