I have a tool grinder E. Hofmann. I am trying to figure out if it is set to 220 or 440. I have hooked it to 220 and it runs but not very fast.
I can not find a schematic and only a couple of the wires are labeled. It is a nine wire, each leg are colored the same. It came to me with one leg all grouped together and not hooked to anything. The other two legs are split into the three line legs.
Thanks
I can not find a schematic and only a couple of the wires are labeled. It is a nine wire, each leg are colored the same. It came to me with one leg all grouped together and not hooked to anything. The other two legs are split into the three line legs.
Thanks